Based on poor results (very low rdf) with no messanger RG6 over a barb
wire fence I built and subsequent modeling that showed this, I think
another parallel conductor near any Beverage is not a good idea. It was
easy to support the plain RG6 with PVC pipes tied to posts and I think
extending the steel fence posts would also be ok, as they are
perpendicular to the wave prop and a tiny fraction of the wavelength.
A messenger steel wire plus its insulation will also likely have more
loss and different prop velocity than the braid/foil of the RG6, so
connecting them together may not work well. Solid copper conductor RG6
is advisable given the 160m skin depth for Cu plating over steel of most
RG6 optimized for 1GHz.
Grant KZ1W
On 1/28/2021 06:40, Kenny Silverman wrote:
What are the mechanical issues and solutions when using RG6 as the beverage
element?
Should cable with a messenger wire always be used? Does the messenger wire get
connected to anything?
Do I need different insulators than used for single wire beverages?
I looked in the archives but I didn’t see anything addressing this.
Many thanks , Kenny K2KW
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector