** Branch linked: lp:curtin -- You received this bug notification because you are a member of Ubuntu Touch seeded packages, which is subscribed to ifupdown in Ubuntu. https://bugs.launchpad.net/bugs/1609367
Title: ifupdown does not set ipv6-only large mtu Status in ifupdown package in Ubuntu: Confirmed Bug description: ifupdown changes a device's mtu differently, between "inet" section mtu and "inet6" section mtu. For "inet", ifupdown changes the device's mtu, using 'ip link set DEV mtu NNN'. However for "inet6", ifupdown changes the interface's IPv6 mtu, using 'sysctl -q -e -w net.ipv6.conf.DEV.mtu=NNN'. The problem is that a device's ipv6 mtu cannot be larger than the device mtu. Normally this is not a problem; the main reason a device needs a separate ipv6 mtu is to support ipv6 tunneling inside ipv4 (e.g. 6in4 or 6rd), so ifupdown would also have a ipv4 "inet" section that contained a larger mtu (or, the ipv6 section would have a lower- than-default mtu). But, in the case of an interface that is configured only for ipv6 *and* large frames (e.g. 9000 mtu), there is only an "inet6" section in the ifupdown config, and so ifupdown fails to set the device's mtu, which causes its attempt to set the ipv6 mtu to fail. I believe the correct behavior is for ifupdown to check if there is any "inet" config section for the same device as the "inet6" section, and if there is not then it should change the device mtu as well as the ipv6 mtu. Additionally, the "inet6" configuration must be done after the "inet" configuration for the same device, since the ipv6 mtu can't be higher than the device mtu. I don't see any easy way to add that logic to inet6.defn, however... To manage notifications about this bug go to: https://bugs.launchpad.net/ubuntu/+source/ifupdown/+bug/1609367/+subscriptions -- Mailing list: https://launchpad.net/~touch-packages Post to : touch-packages@lists.launchpad.net Unsubscribe : https://launchpad.net/~touch-packages More help : https://help.launchpad.net/ListHelp
