bonsoir
si ça peut profiter à d'autres : FICHIER /etc/network/interfaces QUI NE FONCTIONNE PAS : iface wlan0 inet static address 10.0.0.1 netmask 255.255.255.0 auto lo iface lo inet loopback iface eth0 inet dhcp # allow-hotplug wlan0 # iface wlan0 inet manual # wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf iface default inet dhcp up iptables-restore < /etc/iptables.ipv4.nat FICHIER /etc/network/interfaces QUI FONCTIONNE : auto lo iface lo inet loopback iface eth0 inet dhcp # allow-hotplug wlan0 # iface wlan0 inet manual # wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf iface default inet dhcp iface wlan0 inet static address 10.0.0.1 netmask 255.255.255.0 up iptables-restore < /etc/iptables.ipv4.nat honteux d'avoir dû faire le singe... :-( JLP Le vendredi 31 janvier 2014 19:43:57 jlp a écrit : > bonsoir > > en suivant quelques tutos j'ai connecté un TP-LINK TL-WN722N sur > un Raspberry Pi sur lequel était déjà installé un serveur https > > je peux me connecter avec une tablette android qui prend l'adresse > 10.0.0.22 (ça déconne déjà, voir plus bas) > > avec la tablette android je peux surfer en https sur le serveur web > du Raspberry Pi > > mais je ne peux pas aller sur internet avec la tablette android > > je n'arrive plus à voir quelle connerie j'ai pu faire, c'est d'autant > plus pénible que ça avait fonctionné du premier coup l'année > dernière... > > toute aide bienvenue, merci ! > > JLP > > > > > sudo apt-get -y install hostapd udhcpd > > brancher le TP-LINK TL-WN722N > > sudo vi /etc/network/interfaces > iface wlan0 inet static > address 10.0.0.1 > netmask 255.255.255.0 > > auto lo > > iface lo inet loopback > iface eth0 inet dhcp > > # allow-hotplug wlan0 > # iface wlan0 inet manual > # wpa-roam /etc/wpa_supplicant/wpa_supplicant.conf > iface default inet dhcp > up iptables-restore < /etc/iptables.ipv4.nat > > sudo vi /etc/iptables.ipv4.nat > # Generated by iptables-save v1.4.14 on Fri Jan 31 16:05:36 2014 > *filter > > :INPUT ACCEPT [8:416] > :FORWARD ACCEPT [0:0] > :OUTPUT ACCEPT [8:1408] > > -A FORWARD -i eth0 -o wlan0 -m state --state RELATED,ESTABLISHED -j > ACCEPT -A FORWARD -i wlan0 -o eth0 -j ACCEPT > COMMIT > # Completed on Fri Jan 31 16:05:36 2014 > # Generated by iptables-save v1.4.14 on Fri Jan 31 16:05:36 2014 > *nat > > :PREROUTING ACCEPT [0:0] > :INPUT ACCEPT [0:0] > :OUTPUT ACCEPT [1:196] > :POSTROUTING ACCEPT [0:0] > > -A POSTROUTING -o eth0 -j MASQUERADE > COMMIT > # Completed on Fri Jan 31 16:05:36 2014 > > sudo vi /etc/hostapd/hostapd.conf > interface=wlan0 > ssid=MY_SSID > hw_mode=g > channel=6 > auth_algs=1 > wmm_enabled=0 > > wpa=2 > wpa_passphrase=MY_PASSWORD > wpa_key_mgmt=WPA-PSK > wpa_pairwise=TKIP > rsn_pairwise=CCMP > > sudo vi /etc/default/hostapd > DAEMON_CONF="/etc/hostapd/hostapd.conf" > > sudo vi /etc/sysctl.conf > kernel.printk = 3 4 1 3 > net.ipv4.ip_forward=1 > vm.swappiness=1 > vm.min_free_kbytes = 8192 > > sudo vi /etc/default/udhcpd > # Comment the following line to enable > # DHCPD_ENABLED="no" > > # Options to pass to busybox' udhcpd. > # > # -S Log to syslog > # -f run in foreground > > DHCPD_OPTS="-S" > > sudo vi /etc/udhcpd.conf > # Sample udhcpd configuration file (/etc/udhcpd.conf) > > # The start and end of the IP lease block > > start 10.0.0.100 # start 192.168.0.20 #default: > 192.168.0.20 end 10.0.0.199 # end 192.168.0.254 #default: > 192.168.0.254 > > > # The interface that udhcpd will use > > interface wlan0 # interface eth0 #default: eth0 > > > # The maximim number of leases (includes addressesd reserved > # by OFFER's, DECLINE's, and ARP conficts > > #max_leases 254 #default: 254 > > > # If remaining is true (default), udhcpd will store the time > # remaining for each lease in the udhcpd leases file. This is > # for embedded systems that cannot keep time between reboots. > # If you set remaining to no, the absolute time that the lease > # expires at will be stored in the dhcpd.leases file. > > #remaining yes #default: yes > > > # The time period at which udhcpd will write out a dhcpd.leases > # file. If this is 0, udhcpd will never automatically write a > # lease file. (specified in seconds) > > #auto_time 7200 #default: 7200 (2 hours) > > > # The amount of time that an IP will be reserved (leased) for if a > # DHCP decline message is received (seconds). > > #decline_time 3600 #default: 3600 (1 hour) > > > # The amount of time that an IP will be reserved (leased) for if an > # ARP conflct occurs. (seconds > > #conflict_time 3600 #default: 3600 (1 hour) > > > # How long an offered address is reserved (leased) in seconds > > #offer_time 60 #default: 60 (1 minute) > > # If a lease to be given is below this value, the full lease time is > # instead used (seconds). > > #min_lease 60 #defult: 60 > > > # The location of the leases file > > #lease_file /var/lib/misc/udhcpd.leases #defualt: > /var/lib/misc/udhcpd.leases > > # The location of the pid file > #pidfile /var/run/udhcpd.pid #default: /var/run/udhcpd.pid > > # Everytime udhcpd writes a leases file, the below script will be called. > # Useful for writing the lease file to flash every few hours. > > #notify_file #default: (no script) > > #notify_file dumpleases # <--- useful for debugging > > # The following are bootp specific options, setable by udhcpd. > > #siaddr 192.168.0.22 #default: 0.0.0.0 > > #sname zorak #default: (none) > > #boot_file /var/nfs_root #default: (none) > > # The remainer of options are DHCP options and can be specifed with the > # keyword 'opt' or 'option'. If an option can take multiple items, such > # as the dns option, they can be listed on the same line, or multiple > # lines. The only option with a default is 'lease'. > > #Examles > opt dns 212.27.48.10 # opt dns 192.168.10.2 192.168.10.10 > option subnet 255.255.255.0 > opt router 10.0.0.1 # opt router 192.168.10.2 > # opt wins 192.168.10.10 > # option dns 129.219.13.81 # appened to above DNS servers > for a total of 3 option domain local > option lease 864000 # 10 days of seconds > > > # Currently supported options, for more info, see options.c > #opt subnet > #opt timezone > #opt router > #opt timesrv > #opt namesrv > #opt dns > #opt logsrv > #opt cookiesrv > #opt lprsrv > #opt bootsize > #opt domain > #opt swapsrv > #opt rootpath > #opt ipttl > #opt mtu > #opt broadcast > #opt wins > #opt lease > #opt ntpsrv > #opt tftp > #opt bootfile > #opt wpad > > # Static leases map > #static_lease 00:60:08:11:CE:4E 192.168.0.54 > #static_lease 00:60:08:11:CE:3E 192.168.0.44 > > sudo service hostapd restart > > sudo service udhcpd restart -- --------8<--------8<--------8<--------8<--------8<-------- Jean-Louis Patané jl...@free.fr http://jlp31.free.fr/cv.html DES OUTILS GRATUITS POUR PROMOUVOIR MON CV : http://jlp31.free.fr/cvware/index.html LA MUSIQUE ADOUCIT LES MOEURS : http://junkofunk.free.fr/ http://jlpmusic.free.fr/ http://eindharmoniemuret.free.fr/ http://harmoniedauterive.free.fr/ http://jlp31.free.fr/musique.html --------8<--------8<--------8<--------8<--------8<-------- _______________________________________________ Toulouse-ll mailing list Toulouse-ll@toulibre.org http://toulibre.org/cgi-bin/mailman/listinfo/toulouse-ll