The command console is only available on port A, so that is where the PC will have to be connected. Set port A to AUTO to begin with and you can change that on the fly. Set port B to NMEA for your GPS.
Larry K7YBZ --- In [email protected], "Sion Chow Q. C. (9W2QC)" <9w...@...> wrote: > > Dear All, > > I have tried to use the T2 as a mobile APRS tracker yesterday (as > 9W2QC-9) for the first time together with an old Magellan GPS 4000 GPS > receiver with great success. Previously, had only used the T2 as a > mountain top digipeater. (9M4RDG-3 on 2M and 9M4RDC on 70CM) > > I have also tried to make the Y splitter to be able to connect the GPS > into one port (Port B) and the PC into the other port (Port A). > However, I am confused as to how to configure these 2 ports. > > I would like preferably Port B connected to the PC, with the ability > to work command input (for remote control of the digipeater or just to > monitor packets - to test the digipeater's coverage as I travel > around) or KISS (switched as required) and Port A connected to the > Magellan GPS 4000 (this unit provides NMEA output). However, in > OTWINCFG, I cannot find a choice for this setup. Appreciate if anyone > could kindly guide me on how to perform this, or provide any > alternative solutions for this. > > Thank you. > > 73, > Sion Chow Q. C, > 9W2QC, WQ2C >
