So the two amp SSR seems adequate as it's rating is about 15X your load
current. At the start I was assuming the heater would consume a lot more
power!
-Pete
On 12/30/19 1:32 PM, Craig Cook via TriEmbed wrote:
Did you ever (very carefully) measure the voltage across the motor while the
popper was powered?
Oh, I misread your question.
Fan Motor
17 Volts DC at the terminals
0.018 Amps DC
Diodes are attached to turn AC into DC
Heater
Red (hot) and White (ground) wires
113 Volt AC
0.134 Amp AC
Black and White wires
20 Volt AC
Thanks
Craig
_______________________________________________
Triangle, NC Embedded Computing mailing list
To post message: [email protected]
List info: http://mail.triembed.org/mailman/listinfo/triembed_triembed.org
TriEmbed web site: http://TriEmbed.org
To unsubscribe, click link and send a blank message:
mailto:[email protected]?subject=unsubscribe
_______________________________________________
Triangle, NC Embedded Computing mailing list
To post message: [email protected]
List info: http://mail.triembed.org/mailman/listinfo/triembed_triembed.org
TriEmbed web site: http://TriEmbed.org
To unsubscribe, click link and send a blank message:
mailto:[email protected]?subject=unsubscribe
