A lot. The twist pitch time the length should be big enough to make it so
fraction twist won't matter. You're canceling induction and you want the same
ins as outs, so they'll cancel each other. If your run is 12 inches and you
have 1 twist per inch, a missing twist would be 8% of total or 21.5 dB of
reduction. With 3 per inch you'd have <3%, or about 30 dB. The is in theory.
You'd like to have a bit higher pitch since it will give you better "local"
rejection. Twisting and shielding are the hot setup, magnetic and
electrostatic. A few per inch is the kind of number or you pick up
Capacitance. Cat6 is 2 per cm or 5 per inch.Sent from my Verizon, Samsung
Galaxy smartphone
-------- Original message --------From: Mauricio Tavares via TriEmbed
<[email protected]> Date: 7/26/23 8:32 AM (GMT-05:00) To: TriEmbed
Discussion <[email protected]> Subject: [TriEmbed] Wire twist rate If I am
pulling signal off a garden-variety variable reluctancesensor, how much
flexibility do I have with the wire twist
ratio?_______________________________________________Triangle, NC Embedded
Interest Group mailing listTo post message: [email protected] info:
http://mail.triembed.org/mailman/listinfo/triembed_triembed.orgTriEmbed web
site: https://TriEmbed.orgTo unsubscribe, click link and send a blank message:
mailto:[email protected]?subject=unsubscribeSearchable email
archive available at https://www.mail-archive.com/[email protected]/
_______________________________________________
Triangle, NC Embedded Interest Group mailing list
To post message: [email protected]
List info: http://mail.triembed.org/mailman/listinfo/triembed_triembed.org
TriEmbed web site: https://TriEmbed.org
To unsubscribe, click link and send a blank message:
mailto:[email protected]?subject=unsubscribe
Searchable email archive available at
https://www.mail-archive.com/[email protected]/
