> I use DHCP to get my IP address:
> -> setenv autoload no
> -> dhcp
> BOOTP broadcast 1
> DHCP client bound to address XXX.XXX.XXX.152
> -> ping XXX.XXX.XXX.189
> Using FEC0 device
> host XXX.XXX.XXX.189 is alive
I've tried DHCP as well, and I get the following:
-> dhcp
BOOTP broadcast 1
checksum bad
checksum bad
Abort
Have tried pinging the devel computer as well:
-> ping 192.168.1.100
Using FEC0 device
checksum bad
checksum bad
Abort
ping failed; host 192.168.1.100 is not alive
DHCP on the router is working fine; other computers on the LAN get IP
addresses without any trouble. I have also tried using DHCP with the board
plugged into my college's network which uses DHCP, still didn't work. Have
also tried using static IPs with a crossover cable straight from the board
to the computer, and that didn't work either. I'm using FEC0 and have
tested the cable. TsiChung, have you had any Ethernet problems? Is it
possible that I need some other patch that was recently applied?
I modified u-boot.lds to fix the saveenv, and it worked fine for me.
Thanks,
-David
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
U-Boot-Users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/u-boot-users
