Stefan Roese wrote: > Hi Niklaus, > > On Monday 04 February 2008, Niklaus Giger wrote: >> Signed-off-by: Niklaus Giger <[EMAIL PROTECTED]> > > Thanks for splitting this out. But still I have a question. See below. > >> --- >> include/ppc405.h | 4 ++++ >> 1 files changed, 4 insertions(+), 0 deletions(-) >> >> diff --git a/include/ppc405.h b/include/ppc405.h >> index b5ad38f..fbfb681 100644 >> --- a/include/ppc405.h >> +++ b/include/ppc405.h >> @@ -784,6 +784,10 @@ >> #define reset (CNTRL_DCR_BASE+0x3) /* reset register >> */ >> #define strap (CNTRL_DCR_BASE+0x4) /* strap register >> */ >> >> +#ifdef CONFIG_405GPr >> +#define eirr (CNTRL_DCR_BASE+0x6) /* external interrupt routing >> register */ +#endif >> + > > Why is 405GPr needed here? Is this register not available in 405GP? I found the following comments in the Migration guide for the PPC405GP -> PPC405GPr (PPC405GP_AN2023_405GPrMigration__v1_01.pdf). > The 405GPr provides the ability to add six external interrupts to the > seven already available on the 405GP. This is accomplished by logic that > allows routing any of the 24 GPIOs to six previously unused Universal > Interrupt Controller (UIC) inputs. For those GPIOs that are shared with > other functions, the corresponding I/O must first be configured via > CPC0_CR0 to be a GPIO. Table 14 shows how the new GPIO to UIC External > Interrupt Routing Register (CPC0_EIRR) logically routes GPIO inputs used > as interrupts to the UIC. Therefore I concluded that it is very PPC405GPr specific. But I did not check all other PPC405 variants.
Best regards Niklaus ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
