In message <[EMAIL PROTECTED]> you wrote: > According to the OMAP5912 Serial Interfaces Reference Guide (see > http://focus.ti.com/lit/ug/spru760c/spru760c.pdf, page 150), the > FIFO_EN enable bit in the FIFO Control Register (FCR) can only be > changed when the baud clock is not running, i. e. when both DLL and > DLH are set to 0. > > Thus make sure that DLL and DLH are 0 when writing the FCR. > > Signed-off-by: Wolfgang Denk <[EMAIL PROTECTED]>
Applied. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] "It is better to have tried and failed than to have failed to try, but the result's the same." - Mike Dennison ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
