Hi,
I am using U-Boot 1.2.0 release of U-Boot and working on ARM1176
platform. I have ported U-Boot for my platform, which boots from NAND
Flash, save ENV variable onto NAND Flash. Almost everything works fine
for me till now. But today I came across one issue -
When I set baudrate to different value from U-Boot prompt, and do a
"saveenv", and after that if I reboot the system it should boot with new
baudrate set. Ideally it should take new baudrate, but it always
configures default baudrate.
I tried to dig into this issue, and found that, U-Boot for NAND Flash is
designed the same way. The function "nand_init" gets invoked after
"env_init" and "serial_init", and sue to this U-Boot always uses the
default baudrate.
Do I understand it correctly? Is there any way to resolve this issue?
Thanks,
Vaibhav
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
U-Boot-Users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/u-boot-users
