On Friday 15 February 2008, Sean wrote: > I have enabled both UART0 and UART 1 using the CONFIG_SERIAL_MULTI in my > board specific header file. The board is based on PPC 440GX processor. I > used the serial1_puts and serial1_getc to access the UART1 but without > access. Does anybody have used this functions before?
Yes, this was tested successfully on multiple 4xx platforms. I don't remember testing it on a 440GX though. Could be that the pin multiplexing is not initialized correctly. Please recheck that the GPIO configuration and the PFC registers are setup correctly for UART1. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: [EMAIL PROTECTED] ===================================================================== ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
