In message <[EMAIL PROTECTED]> you wrote: > There were differences in the PHY setup between Linux and U-Boot. > > This patch fixes the problem. Apparently "remote fault" is being set, > which signals to some devices (on the other end of the cable) that a > fault has occurred, while other devices ignore it. I believe the RF bit > was causing the issue, but I removed T4 also, to match up with Linux. > > Signed-off-by: Mike Nuss <[EMAIL PROTECTED]>
Applied, thanks. Note: you might also try enabling the (new) CONFIG_PHY_DYNAMIC_ANEG option on your board; this works for us, too. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] I express preference for a chronological sequence of events which precludes a violence. - Terry Pratchett, _The Dark Side of the Sun_ ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
