In message <[EMAIL PROTECTED]> you wrote:
>
> > As far as I managed to understand, reginfo just shows a dump of CPU
> > based register values, while pario allows you to set and get the value
> > of a GPIO port - two different things. We found this very useful for
> > debugging our board, and I think it can be useful for many other
> > processor families as well.
>
> There is also a "qe" command that takes sub-commands as a parameter.
> Currently,
> the only one is "qe fw" for uploading firmware. Perhaps you could do "qe
> pario"?
Please don;t.
Instead of adding such functionality several times in several places
distributed all over the whole source tree, let's do it just once and
right.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED]
Even historians fail to learn from history -- they repeat the same
mistakes.
-- John Gill, "Patterns of Force", stardate 2534.7
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
_______________________________________________
U-Boot-Users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/u-boot-users
