I've been working last months on a lubbock board and u-boot as a bootloader
to run Linux. I always loaded my kernel via serial port, because I never got
u-boot to activate my ethernet (I never got the link led on, only after
booting Linux).
I recently read the FAQ again and found about using valid MAC addresses:
* Should I recompile my u-boot with the new local-admin MAC address or just
I need to write the new config on the board?
Thanks.
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
U-Boot-Users mailing list
U-Boot-Users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/u-boot-users
