Dear Stefan Roese, In message <[EMAIL PROTECTED]> you wrote: > > This will not work. Take a look at the lwmon5 configuration. It has a similar > Intel FLASH which has two chips inside: > > #define CFG_FLASH0 0xFC000000 > #define CFG_FLASH1 0xF8000000 > #define CFG_FLASH_BANKS_LIST { CFG_FLASH1, CFG_FLASH0 } > > #define CFG_MAX_FLASH_BANKS 2 > > ... > > You need to change the addresses for your 32MB version though.
Please note that I really dislike such static configurations which will break as soon as the size of the flash banks changes. Right from the begining U-Boot was always designed to allow for dynamic adjustment to the actual memory sizes found on the boards, and we should just use this capability. Assuming a 32 bit configuration, above should rather be written as: #define CFG_FLASH0 (0 - flash_info[0].size) #define CFG_FLASH1 (CFG_FLASH0 - flash_info[1].size) #define CFG_FLASH_BANKS_LIST { CFG_FLASH1, CFG_FLASH0 } ... This may require a preliminary mapping of the flash banks that is then fixed after the CFI driver determined the real size; see for example how this was done for the TQM8xx* boards (of course this needs to be adapted for 4xx, but you get the idea). Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [EMAIL PROTECTED] "We don't care. We don't have to. We're the Phone Company." _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot