The following improvements are made and tested on my HCUx boards:
README
- document bootvx and CONFIG_SYS_VXWORKS parameters
vxworks.h
- add new vxworks.h with some default definitions
cmd_elf.c
- fix size too small by one in sprintf
- changed old (pre 2004) device name ibmEmac to emac
- boot device may be overriden in board config
- servername may be defined in board config
- additional parameters may be defined in board config
- fixed some line wrappings
- replaced redundant MAX define by max
netstal-common.h
use new CONFIG_SYS_VXWORKS parameters
Signed-off-by: Niklaus Giger <[EMAIL PROTECTED]>
---
README | 18 ++++++++++++++++++
1 files changed, 18 insertions(+), 0 deletions(-)
diff --git a/README b/README
index ebee20f..10c2cec 100644
--- a/README
+++ b/README
@@ -379,6 +379,24 @@ The following options need to be configured:
This define fills in the correct boot CPU in the boot
param header, the default value is zero if undefined.
+- vxWorks boot parameters:
+
+ bootvx constructs a valid bootline using the following
+ environments variables: bootfile, ipaddr, serverip, hostname.
+ It loads the vxWorks image pointed bootfile.
+
+ CONFIG_SYS_VXWORKS_BOOT_DEVICE - The vxworks device name
+ CONFIG_SYS_VXWORKS_MAC_PTR - Ethernet 6 byte MA -address
+ CONFIG_SYS_VXWORKS_SERVERNAME - Name of the server
+ CONFIG_SYS_VXWORKS_BOOT_ADDR - Address of boot parameters
+
+ CONFIG_SYS_VXWORKS_ADD_PARAMS
+
+ Add it at the end of the bootline. E.g "u=username pw=secret"
+
+ Note: If a "bootargs" environment is defined, it will overwride
+ the defaults discussed just above.
+
- Serial Ports:
CONFIG_PL010_SERIAL
--
1.6.0.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
