Hi Frederic,
The patches look good in general, but unfortunately you mailer turned
tabs into spaces and wrapped long lines, so the patches do not apply.
Can you send them again please?
one comment inline.
Thanks
Sascha
On Thu, Dec 11, 2008 at 02:14:41PM +0100, frederic Rodo wrote:
> Signed-off-by:Frederic Rodo <fred.r...@gmail.com>
> ---
> drivers/nand/nand_imx.c | 94
> +++++++++++++++++++++++++++++------
> include/asm-arm/arch-imx/imx-nand.h | 2 +-
> 2 files changed, 79 insertions(+), 17 deletions(-)
>
> diff --git a/drivers/nand/nand_imx.c b/drivers/nand/nand_imx.c
> index f7f50b0..3bf67de 100644
> --- a/drivers/nand/nand_imx.c
> +++ b/drivers/nand/nand_imx.c
> @@ -1090,26 +1090,74 @@ static struct driver_d imx_nand_driver = {
>
> static void __nand_boot_init nfc_addr(struct imx_nand_host *host, u32 offs)
> {
> - send_addr(host, offs & 0xff);
> - send_addr(host, (offs >> 9) & 0xff);
> - send_addr(host, (offs >> 17) & 0xff);
> - send_addr(host, (offs >> 25) & 0xff);
> + if (!host->pagesize_2k) {
Can you turn this into positive logic?
> + send_addr(host, offs & 0xff);
> + send_addr(host, (offs >> 9) & 0xff);
> + send_addr(host, (offs >> 17) & 0xff);
> + send_addr(host, (offs >> 25) & 0xff);
> + } else {
> + /* imx27 Nand flash controller can only read full 2k page */
> + send_addr(host, 0);
> + send_addr(host, 0);
> + send_addr(host, (offs >> 11) & 0xff);
> + send_addr(host, (offs >> 19) & 0xff);
> + /* FIXME: add another send_addr for nandflash > 1Gbit
> + * if (read electronic signature byte 5 > 1 Gbit)
> + * send_addr(host, (offs >> 28) & 0xff);
> + */
> +
> + /* send read start command */
> + send_cmd(host, NAND_CMD_READSTART);
> + }
> }
>
> -static int __nand_boot_init block_is_bad(struct imx_nand_host *host,
> u32 offs)
> +static int __nand_boot_init block_is_bad(struct imx_nand_host *host,
> u32 offs,
> + u32 pagesize)
> {
> - send_cmd(host, NAND_CMD_READOOB);
> - nfc_addr(host, offs);
> - send_read_page(host, 0, 1);
> -
> - return (readw(host->regs + SPARE_AREA0) & 0xff) == 0xff ? 0 : 1;
> + if (!host->pagesize_2k) {
dito
> + send_cmd(host, NAND_CMD_READOOB);
> + nfc_addr(host, offs);
> + send_read_page(host, 0, 1);
> + if ((readw(host->regs + SPARE_AREA0) & 0xff) != 0xff)
> + return 1;
> + } else {
> + /* The AdvancedToolKit Mark the two first page of each block */
> + /* check first page */
> + send_cmd(host, NAND_CMD_READ0);
> + nfc_addr(host, offs);
> + send_read_page(host, 0, 1);
> + send_read_page(host, 1, 1);
> + send_read_page(host, 2, 1);
> + send_read_page(host, 3, 1);
> +
> + if (readw(host->regs + NFC_ECC_STATUS_RESULT) & 0xa)
> + return 1;
> +
> + if ((readw(host->regs + SPARE_AREA0 + 4) & 0xFF00) != 0xFF00)
> + return 1;
> +
> + /* check second page */
> + send_cmd(host, NAND_CMD_READ0);
> + nfc_addr(host, offs + pagesize);
> + send_read_page(host, 0, 1);
> + send_read_page(host, 1, 1);
> + send_read_page(host, 2, 1);
> + send_read_page(host, 3, 1);
> +
> + if (readw(host->regs + NFC_ECC_STATUS_RESULT) & 0xa)
> + return 1;
> +
> + if ((readw(host->regs + SPARE_AREA0 + 4) & 0xFF00) != 0xFF00)
> + return 1;
> +
> + }
> + return 0;
> }
>
> -void __nand_boot_init imx_nand_load_image(void *dest, int size, int
> pagesize,
> - int blocksize)
> +void __nand_boot_init imx_nand_load_image(void *dest, int size, int
> blocksize)
> {
> struct imx_nand_host host;
> - u32 tmp, page, block;
> + u32 tmp, page, block, pagesize;
>
> PCCR1 |= PCCR1_NFC_BAUDEN;
>
> @@ -1117,6 +1165,10 @@ void __nand_boot_init imx_nand_load_image(void
> *dest, int size, int pagesize,
> case GPCR_BOOT_8BIT_NAND_2k:
> case GPCR_BOOT_16BIT_NAND_2k:
> host.pagesize_2k = 1;
> + pagesize = 2048;
> + break;
> + default:
> + pagesize = 512;
> }
>
> host.regs = (void __iomem *)IMX_NFC_BASE;
> @@ -1134,14 +1186,19 @@ void __nand_boot_init imx_nand_load_image(void
> *dest, int size, int pagesize,
> /* Unlock Block Command for given address range */
> writew(0x4, host.regs + NFC_WRPROT);
>
> + /* clear all operation */
> + writew(0x8000, host.regs + NFC_CONFIG1);
> +
> + /* enable ECC, disable spare only and interrupt */
> tmp = readw(host.regs + NFC_CONFIG1);
> - tmp |= NFC_ECC_EN;
> + tmp |= NFC_ECC_EN | NFC_INT_MSK;
> + tmp &= ~ NFC_SP_EN;
> writew(tmp, host.regs + NFC_CONFIG1);
>
> block = page = 0;
>
> while (1) {
> - if (!block_is_bad(&host, block * blocksize)) {
> + if (!block_is_bad(&host, block * blocksize, pagesize)) {
> page = 0;
> while (page * pagesize < blocksize) {
> debug("page: %d block: %d dest: %p src "
> @@ -1154,8 +1211,13 @@ void __nand_boot_init imx_nand_load_image(void
> *dest, int size, int pagesize,
> nfc_addr(&host, block * blocksize +
> page * pagesize);
> send_read_page(&host, 0, 0);
> + if (host.pagesize_2k) {
> + send_read_page(&host, 1, 0);
> + send_read_page(&host, 2, 0);
> + send_read_page(&host, 3, 0);
> + }
> page++;
> - memcpy32(dest, host.regs, 512);
> + memcpy32(dest, host.regs, pagesize);
> dest += pagesize;
> size -= pagesize;
> if (size <= 0)
> diff --git a/include/asm-arm/arch-imx/imx-nand.h
> b/include/asm-arm/arch-imx/imx-nand.h
> index 5ebe0be..eca8fef 100644
> --- a/include/asm-arm/arch-imx/imx-nand.h
> +++ b/include/asm-arm/arch-imx/imx-nand.h
> @@ -3,7 +3,7 @@
>
> #include <linux/mtd/mtd.h>
>
> -void imx_nand_load_image(void *dest, int size, int pagesize, int
> blocksize);
> +void imx_nand_load_image(void *dest, int size, int blocksize);
>
> struct imx_nand_platform_data {
> int width;
> --
> 1.4.4.4
>
>
>
> -------------------------------------------------------------------------
> Les informations précédentes peuvent être confidentielles ou privilégiées.
> Si vous n'êtes pas le destinataire prévu de ce mail, veuillez en notifier
> l'expéditeur en répondant à ce message puis supprimez-en toute trace
> de vos systèmes.
>
> TIL Technologies
> Parc du Golf, Bat 43
> 350 rue J.R Guilibert Gautier de la Lauzière
> 13856 AIX EN PROVENCE
> Tel. : +33 4 42 37 11 77
> -------------------------------------------------------------------------
>
>
>
--
Pengutronix e.K. | |
Linux Solutions for Science and Industry | Phone: +49-5121-206917-0 |
Peiner Strasse 6-8, 31137 Hildesheim, Germany | Fax: +49-5121-206917-5555 |
Amtsgericht Hildesheim, HRA 2686 | http://www.pengutronix.de |
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
