If CONFIG_NAND_ECC_BCH is set we use 4-bit error corretion code
instead of the 1-bit error correction code on the NAND device
within this driver.
Signed-off-by: Holger Brunck <holger.bru...@keymile.com>
cc: Scott Wood <scottw...@freescale.com>
---
drivers/mtd/nand/kmeter1_nand.c | 4 ++++
1 files changed, 4 insertions(+), 0 deletions(-)
diff --git a/drivers/mtd/nand/kmeter1_nand.c b/drivers/mtd/nand/kmeter1_nand.c
index e8e5b7b..f044597 100644
--- a/drivers/mtd/nand/kmeter1_nand.c
+++ b/drivers/mtd/nand/kmeter1_nand.c
@@ -119,7 +119,11 @@ static int kpn_nand_dev_ready(struct mtd_info *mtd)
int board_nand_init(struct nand_chip *nand)
{
+#if defined(CONFIG_NAND_ECC_BCH)
+ nand->ecc.mode = NAND_ECC_SOFT_BCH;
+#else
nand->ecc.mode = NAND_ECC_SOFT;
+#endif
/* Reference hardware control function */
nand->cmd_ctrl = kpn_nand_hwcontrol;
--
1.7.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
