On 07/02/2013 17:45, Fabio Estevam wrote: > On a mx6qsabresd revision C board with rev1.2 mx6q, the system gets resetted > and it is not able to reach the Linux prompt. > > Comparing the watchdog behaviour on a revB versus revC board: > > - On a mx6qsabresd revB: > > U-Boot > reset > resetting ... > > U-Boot 2013.01-10524-g432a3aa-dirty (Feb 07 2013 - 13:34:46) > > CPU: Freescale i.MX6Q rev1.1 at 792 MHz > Reset cause: WDOG > ... > > - On a mx6qsabresd revC: > > U-Boot > reset > resetting ... > > U-Boot 2013.01-10524-g432a3aa-dirty (Feb 07 2013 - 13:34:46) > > CPU: Freescale i.MX6Q rev1.1 at 792 MHz > Reset cause: POR > > So due to revC POR/watchdog circuitry whenever a watchdog occurs, it causes a > POR. > > Clearing the PDE - Power Down Enable bit of WMCR registers fixes the problem > and > is also safe for all mx6 boards. > > Signed-off-by: Fabio Estevam <fabio.este...@freescale.com> > ---
Applied to u-boot-imx, thanks. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot