On Mon, Apr 15, 2013 at 10:54 AM, Fabio Estevam <feste...@gmail.com> wrote: > On Mon, Apr 15, 2013 at 10:35 AM, Otavio Salvador > <ota...@ossystems.com.br> wrote: > >> int board_mmc_init(bd_t *bis) >> { >> - imx_iomux_v3_setup_multiple_pads(usdhc3_pads, >> ARRAY_SIZE(usdhc3_pads)); >> - >> - usdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC3_CLK); >> - usdhc_cfg[0].max_bus_width = 4; >> - gpio_direction_input(USDHC3_CD_GPIO); >> + int i; >> + >> + /* >> + * According to the board_mmc_init() the following map is done: >> + * (U-boot device node) (Physical Port) >> + * mmc0 SOM MicroSD >> + * mmc1 Carrier board MicroSD >> + */ >> + for (i = 0; i < CONFIG_SYS_FSL_USDHC_NUM; i++) { >> + switch (i) { >> + case 0: >> + imx_iomux_v3_setup_multiple_pads( >> + usdhc3_pads, ARRAY_SIZE(usdhc3_pads)); >> + usdhc_cfg[0].sdhc_clk = >> mxc_get_clock(MXC_ESDHC3_CLK); >> + usdhc_cfg[0].max_bus_width = 4; >> + gpio_direction_input(USDHC3_CD_GPIO); >> + break; >> + case 1: >> + imx_iomux_v3_setup_multiple_pads( >> + usdhc1_pads, ARRAY_SIZE(usdhc1_pads)); >> + usdhc_cfg[1].sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK); >> + usdhc_cfg[1].max_bus_width = 4; >> + gpio_direction_input(USDHC1_CD_GPIO); >> + break; >> + default: >> + printf("Warning: you configured more USDHC >> controllers" >> + "(%d) than supported by the board\n", i + >> 1); >> + return 0; > > This should be an error. What about return -EINVAL ?
Agreed, fixed locally. >> + } >> + >> + if (fsl_esdhc_initialize(bis, &usdhc_cfg[i])) >> + printf("Warning: failed to initialize mmc dev %d\n", >> i); >> + } >> >> - return fsl_esdhc_initialize(bis, &usdhc_cfg[0]); >> + return 0; > > With this change, you never return an error. Should we fail if *any* fail? -- Otavio Salvador O.S. Systems E-mail: ota...@ossystems.com.br http://www.ossystems.com.br Mobile: +55 53 9981-7854 http://projetos.ossystems.com.br _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot