Hi Joe,
On 5/24/2013 05:58, Joe Hershberger wrote:
Hi,
On Thu, May 23, 2013 at 1:51 AM, Andreas Bießmann
<andreas.de...@googlemail.com> wrote:
Hi Bo,
On 22.05.13 10:45, Bo Shen wrote:
Hi Andreas,
On 5/14/2013 05:31, Joe Hershberger wrote:
On Sun, May 12, 2013 at 6:33 AM, Andreas Bießmann
<andreas.de...@googlemail.com> wrote:
Dear Bo Shen,
On 12.03.2013 07:15, Bo Shen wrote:
Add macb support for sama5d3x devices
Signed-off-by: Bo Shen <voice.s...@atmel.com>
---
change in v2:
No change
---
drivers/net/macb.c | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/drivers/net/macb.c b/drivers/net/macb.c
index 8bacbda..9e7fbc6 100644
--- a/drivers/net/macb.c
+++ b/drivers/net/macb.c
@@ -469,7 +469,8 @@ static int macb_init(struct eth_device *netdev,
bd_t
*bd)
#if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20)
|| \
defined(CONFIG_AT91SAM9G45) ||
defined(CONFIG_AT91SAM9M10G45) || \
- defined(CONFIG_AT91SAM9XE) || defined(CONFIG_AT91SAM9X5)
+ defined(CONFIG_AT91SAM9XE) || defined(CONFIG_AT91SAM9X5) || \
+ defined(CONFIG_SAMA5D3)
I would like to apply http://patchwork.ozlabs.org/patch/239064/
instead of
this one.
Joe, do you have any objections?
Agreed.
Just remind to take this patch: net: macb: using AT91FAMILY replace
#ifdeferry (http://patchwork.ozlabs.org/patch/239064/). or else the macb
won't work with sama5d3xek board.
I thought this would go through Joe's tree. There are some patches
delegated to him regarding sama5 network too (gmac). I could pick up
this single patch however, lets wait some days for Joe to work on the
whole series.
Yes, I hope to be getting to patches assigned to me in patchwork in
the next week or so.
When will these patches will be dealt.
-Joe
Best Regards,
Bo Shen
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
