Hi Tom, On 07/15/2013 04:33 PM, Tom Rini wrote: >> SPL already has GD set to the correct location (in s_init), we mustn't >> move it around now since some data (clocks etc) is already present. >> >> This error was detected on the SPL port for the Compulab CM-T35 board >> (OMAP3530). >> >> Signed-off-by: Stefan Roese <s...@denx.de> >> Cc: Tom Rini <tr...@ti.com> >> Cc: Albert ARIBAUD <albert.u.b...@aribaud.net> > > While we have a problem here, it's not a problem that's visible on > current SPL using platforms, just the CM-T35, yes?
Thats what I noticed as well. I was a bit astonished that I didn't see it on beagle. It should hit there too. > I just gave my > beagleboard (classic and xM) a spin and they're OK. Did you also power-cycle the board (cold boot)? > I've got a few more > platforms I can dig out if needed, but I'm inclined to hold this until > after v2013.07 and we can take one of the paths Albert outlined (change > s_init to system_init, add to the function table, call that way). Does > that work or have I underestimated the impact of this issue? Thanks! I can definitely live with postponing this solution/fix to after this release. Since your tests on the beagle boards are also working fine, then lets just hold this patch and release v2013.07 now. Thanks, Stefan _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot