On 15/07/2013 15:58, Dirk Behme wrote: > Setting the direction and an output value should be done by > > First, set the desired output value. > > Then, switch to output. > > If this is done in the inverse order, like at the moment, > there can be a glitch on the GPIO line while switching first > the old output value and aftwards the new one. > > Fix this by inverting the order of the direction/set_value > calls. > > Signed-off-by: Dirk Behme <dirk.be...@de.bosch.com> > ---
Applied to u-boot-imx, thanks ! Best regards, SWtefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot