Dear Joel Fernandes, > As seen on GCC 4.6 Linaro compiler, control_req buffer is not aligned > on 4 byte boundaray causing data aborts in eth_setup -> conf_buf > during dhcp boot over usb_ether. Fix the issue my aligning control_req > buffer to 4-byte boundary. > > Tested on am335x_evm platform (beaglebone). > Applies on 2013.10-rc1 branch. > > Cc: Tom Rini <tr...@ti.com> > Signed-off-by: Joel Fernandes <jo...@ti.com>
Please keep me in the CC next time. > --- > drivers/usb/gadget/ether.c | 2 +- > 1 file changed, 1 insertion(+), 1 deletion(-) > > diff --git a/drivers/usb/gadget/ether.c b/drivers/usb/gadget/ether.c > index 579893c..251d7b2 100644 > --- a/drivers/usb/gadget/ether.c > +++ b/drivers/usb/gadget/ether.c > @@ -849,7 +849,7 @@ static struct usb_gadget_strings stringtab = { > }; > > /*======================================================================== > ====*/ -static u8 control_req[USB_BUFSIZ]; > +static u8 control_req[USB_BUFSIZ] __attribute__ ((aligned(4))); Please make this cacheline aligned, so we get rid of bounce buffering of the requests on stupid hardware. > #if defined(CONFIG_USB_ETH_CDC) || defined(CONFIG_USB_ETH_RNDIS) > static u8 status_req[STATUS_BYTECOUNT] __attribute__ ((aligned(4))); This could also use fixing, but the STATUS_BYTECOUNT would need to be up-aligned as well then. Some DEFINE_CACHE_ALIGN_BUFFER might help in both cases here. > #endif Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot