On Friday 17 April 2009, prathika wrote: > i have ported u-boot this way to my board with few changes in the u-boot > source code and the board is up and i have tested stand alone > application execution also.
So you did a "real" board port to your custom board? Or did you "just" change the yosemite files? > Now as my requirement is that my console should be on UART2 as my UART0 > and UART1 are coming out as RS 422 lines and only UART2 is RS232. I did > some patch up work on UART0 lines and tested my u-boot porting. Ah, I though you wanted the console on UART1. Ok, then my solution does not work for you. > I added a line > > #define UART2_BASE CFG_PERIPHERAL_BASE + 0x500 > > I have now changed as below and I commented checking for #define > UART0_CONSOLE and #define UART1_CONSOLE: > > #define UARTBASE UART2_BASE > > Is this OK?? Best would be to add the 3rd UART (UART2) to the SERIAL_MULTI infrastructure (see end of serial.c) and use this device as "stdin/stdout/.." in your default environment. Best regards, Stefan ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot