This reads the kernel, ftd and boot into ubifs filesystem. While on
that, the SD firmware filename definition has been moved next to the
other SD related commands.
Signed-off-by: Otavio Salvador <ota...@ossystems.com.br>
---
include/configs/mx28evk.h | 18 +++++++++++++++++-
1 file changed, 17 insertions(+), 1 deletion(-)
diff --git a/include/configs/mx28evk.h b/include/configs/mx28evk.h
index 27b1a41..e40df09 100644
--- a/include/configs/mx28evk.h
+++ b/include/configs/mx28evk.h
@@ -163,7 +163,6 @@
#define CONFIG_EXTRA_ENV_SETTINGS \
"update_nand_full_filename=u-boot.nand\0" \
"update_nand_firmware_filename=u-boot.sb\0" \
- "update_sd_firmware_filename=u-boot.sd\0" \
"update_nand_firmware_maxsz=0x100000\0" \
"update_nand_stride=0x40\0" /* MX28 datasheet ch. 12.12 */ \
"update_nand_count=0x4\0" /* MX28 datasheet ch. 12.12 */ \
@@ -191,6 +190,23 @@
"nand write ${loadaddr} ${fcb_sz} ${filesize} ; " \
"nand write ${loadaddr} ${fw_off} ${filesize} ; " \
"fi\0" \
+ "nandargs=setenv bootargs console=${console_mainline},${baudrate} " \
+ "rootfstype=ubifs ubi.mtd=6 root=ubi0_0 ${mtdparts}\0" \
+ "nandboot=" /* Boot from NAND */ \
+ "mtdparts default; " \
+ "run nandargs; " \
+ "nand read ${loadaddr} kernel 0x00400000; " \
+ "if test ${boot_fdt} = yes; then " \
+ "nand read ${fdt_addr} fdt 0x00080000; " \
+ "bootm ${loadaddr} - ${fdt_addr}; " \
+ "else " \
+ "if test ${boot_fdt} = no; then " \
+ "bootm; " \
+ "else " \
+ "echo \"ERROR: Set boot_fdt to yes or no.\"; " \
+ "fi; " \
+ "fi\0" \
+ "update_sd_firmware_filename=u-boot.sd\0" \
"update_sd_firmware=" /* Update the SD firmware partition */ \
"if mmc rescan ; then " \
"if tftp ${update_sd_firmware_filename} ; then " \
--
1.8.4.rc3
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
