During boot the boot pin configuration is copied to the SBMR registers. This patch adds a function to read the boot device from SBMR.
Signed-off-by: Edward Lin <edward....@technexion.com> Signed-off-by: Richard Hu <richard...@technexion.com> --- arch/arm/cpu/armv7/mx6/soc.c | 43 +++++++++++++++++++++++++++++++ arch/arm/include/asm/arch-mx6/sys_proto.h | 17 ++++++++++++ 2 files changed, 60 insertions(+) diff --git a/arch/arm/cpu/armv7/mx6/soc.c b/arch/arm/cpu/armv7/mx6/soc.c index a390296..6bacdab 100644 --- a/arch/arm/cpu/armv7/mx6/soc.c +++ b/arch/arm/cpu/armv7/mx6/soc.c @@ -243,6 +243,49 @@ void s_init(void) writel(mask528, &anatop->pfd_528_clr); } +enum mx6_boot_device imx_get_boot_device(void) +{ + uint soc_sbmr = readl(SRC_BASE_ADDR + 0x4); + uint bt_mem_ctl = (soc_sbmr & 0x000000FF) >> 4 ; + uint bt_mem_type = (soc_sbmr & 0x00000008) >> 3; + uint bt_mem_mmc = (soc_sbmr & 0x00001000) >> 12; + + switch (bt_mem_ctl) { + case 0x0: + if (bt_mem_type) + return MX6_ONE_NAND_BOOT; + else + return MX6_WEIM_NOR_BOOT; + break; + case 0x2: + return MX6_SATA_BOOT; + break; + case 0x3: + if (bt_mem_type) + return MX6_I2C_BOOT; + else + return MX6_SPI_NOR_BOOT; + break; + case 0x4: + case 0x5: + if (bt_mem_mmc) + return MX6_SD0_BOOT; + else + return MX6_SD1_BOOT; + break; + case 0x6: + case 0x7: + return MX6_MMC_BOOT; + break; + case 0x8 ... 0xf: + return MX6_NAND_BOOT; + break; + default: + return MX6_UNKNOWN_BOOT; + break; + } +} + #ifdef CONFIG_IMX_HDMI void imx_enable_hdmi_phy(void) { diff --git a/arch/arm/include/asm/arch-mx6/sys_proto.h b/arch/arm/include/asm/arch-mx6/sys_proto.h index 8c21364..b26955e 100644 --- a/arch/arm/include/asm/arch-mx6/sys_proto.h +++ b/arch/arm/include/asm/arch-mx6/sys_proto.h @@ -17,6 +17,21 @@ #define MXC_CPU_MX6SOLO 0x62 #define MXC_CPU_MX6Q 0x63 +enum mx6_boot_device { + MX6_SD0_BOOT, + MX6_SD1_BOOT, + MX6_MMC_BOOT, + MX6_NAND_BOOT, + MX6_SATA_BOOT, + MX6_WEIM_NOR_BOOT, + MX6_ONE_NAND_BOOT, + MX6_PATA_BOOT, + MX6_I2C_BOOT, + MX6_SPI_NOR_BOOT, + MX6_UNKNOWN_BOOT, + MX6_BOOT_DEV_NUM = MX6_UNKNOWN_BOOT, +}; + #define is_soc_rev(rev) ((get_cpu_rev() & 0xFF) - rev) u32 get_cpu_rev(void); @@ -31,6 +46,8 @@ unsigned imx_ddr_size(void); void set_vddsoc(u32 mv); +enum mx6_boot_device imx_get_boot_device(void); + /* * Initializes on-chip ethernet controllers. * to override, implement board_eth_init() -- 1.8.0 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot