On 06.12.2013 07:22, Gupta, Pekon wrote: >> From: Gupta, Pekon >> Subject: [PATCH v9 0/4] mtd: nand: omap: optimize OMAP NAND driver >> >> OMAP NAND drivers support various ecc-schemes like (HAM1, BCH4, BCH8..) >> And, each ecc-scheme usually has 2 implementations >> - HAM1_HW or BCHx_HW (using in-build h/w engine for all computation) >> - HAM1_SW or BCHx_HW_DETECTION_SW) (using software library for some >> computation) >> >> This patch series is Part-2 (split) from earlier series, as mentioned below: >> http://lists.denx.de/pipermail/u-boot/2013-November/167270.html >> >> This series aims at following: >> - cleans-up redundant code, duplicate in different ecc-schemes >> - optimizes ecc calculation and correction paths >> - improves scalability and readability, for adding newer ecc-schemes in >> future. >> - updates following callbacks for different ecc-schmes: >> [PATCH 1/4] nand_chip->ecc.hwctl(): configures h/w controller before for >> Read/Write acccess >> [PATCH 2/4] nand_chip->ecc.calculate(): calculates and fetches ECC syndrome >> from h/w controller. >> [PATCH 3/4] nand_chip->ecc.correct(): detects and corrects ECC errors on >> read access >> [PATCH 4/4] update doc and README >> >> >> *changes in v9* >> - split from main series, rebased and forked independently >> > > Request you to please review this series. And accept it if it looks okay. > > And a bug-fix which causes regression for x8 NAND devices > using HAM1 ecc-scheme. This was reported & (un-officially) > tested by Stefan Roese <s...@denx.de>.
I tested this patch series plus the fix from Pekon on an x8 and x16 OMAP3530 board. Both without any problems. So for this series: Tested-by: Stefan Roese <s...@denx.de> Thanks, Stefan _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
