From: Markus Niebel <markus.nie...@tqs.de>
SPI_MODE_3 requires clk high when inactive. The SCLK_CTL
field of the config reg was not configured in case of CPOL.
Fix configuration so that SPI_MODE_3 which uses CPOL configures
the clk line to be high in inactive state.
Signed-off-by: Markus Niebel <markus.nie...@tqs.de>
---
changes for v3:
- correct generation of subject prefix
changes for v2:
- split original patch into two
- improve commit message
---
drivers/spi/mxc_spi.c | 9 +++++++--
1 file changed, 7 insertions(+), 2 deletions(-)
diff --git a/drivers/spi/mxc_spi.c b/drivers/spi/mxc_spi.c
index 95dd03f..f3f029d 100644
--- a/drivers/spi/mxc_spi.c
+++ b/drivers/spi/mxc_spi.c
@@ -115,7 +115,8 @@ static s32 spi_cfg_mxc(struct mxc_spi_slave *mxcs, unsigned
int cs,
{
u32 clk_src = mxc_get_clock(MXC_CSPI_CLK);
s32 reg_ctrl, reg_config;
- u32 ss_pol = 0, sclkpol = 0, sclkpha = 0, pre_div = 0, post_div = 0;
+ u32 ss_pol = 0, sclkpol = 0, sclkpha = 0, sclkctl = 0;
+ u32 pre_div = 0, post_div = 0;
struct cspi_regs *regs = (struct cspi_regs *)mxcs->base;
if (max_hz == 0) {
@@ -164,8 +165,10 @@ static s32 spi_cfg_mxc(struct mxc_spi_slave *mxcs,
unsigned int cs,
if (mode & SPI_CS_HIGH)
ss_pol = 1;
- if (mode & SPI_CPOL)
+ if (mode & SPI_CPOL) {
sclkpol = 1;
+ sclkctl = 1;
+ }
if (mode & SPI_CPHA)
sclkpha = 1;
@@ -180,6 +183,8 @@ static s32 spi_cfg_mxc(struct mxc_spi_slave *mxcs, unsigned
int cs,
(ss_pol << (cs + MXC_CSPICON_SSPOL));
reg_config = (reg_config & ~(1 << (cs + MXC_CSPICON_POL))) |
(sclkpol << (cs + MXC_CSPICON_POL));
+ reg_config = (reg_config & ~(1 << (cs + MXC_CSPICON_CTL))) |
+ (sclkctl << (cs + MXC_CSPICON_CTL));
reg_config = (reg_config & ~(1 << (cs + MXC_CSPICON_PHA))) |
(sclkpha << (cs + MXC_CSPICON_PHA));
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
