Dear Ilya Yanok, In message <1241634633-13917-3-git-send-email-ya...@emcraft.com> you wrote: > UART hardware on i.MX27 is the same as on the i.MX31 so we just > need to provide the driver with correct address of the registers. > > Signed-off-by: Ilya Yanok <ya...@emcraft.com> > --- > drivers/serial/serial_mx31.c | 21 +++++++++++++++++++++ > 1 files changed, 21 insertions(+), 0 deletions(-) > > diff --git a/drivers/serial/serial_mx31.c b/drivers/serial/serial_mx31.c > index 7c0682a..acc5b7d 100644 > --- a/drivers/serial/serial_mx31.c > +++ b/drivers/serial/serial_mx31.c > @@ -18,7 +18,12 @@ > */ > > #include <common.h> > +#ifdef CONFIG_MX31 > #include <asm/arch/mx31.h> > +#else > +#include <asm/arch/imx-regs.h> > +#include <asm/arch/clock.h> > +#endif > > #define __REG(x) (*((volatile u32 *)(x))) > > @@ -32,6 +37,18 @@ > #define UART_PHYS 0x43fb0000 > #elif defined(CONFIG_SYS_MX31_UART5) > #define UART_PHYS 0x43fb4000 > +#elif defined(CONFIG_SYS_MX27_UART1) > +#define UART_PHYS 0x1000a000 > +#elif defined(CONFIG_SYS_MX27_UART2) > +#define UART_PHYS 0x1000b000 > +#elif defined(CONFIG_SYS_MX27_UART3) > +#define UART_PHYS 0x1000c000 > +#elif defined(CONFIG_SYS_MX27_UART4) > +#define UART_PHYS 0x1000d000 > +#elif defined(CONFIG_SYS_MX27_UART5) > +#define UART_PHYS 0x1001b000 > +#elif defined(CONFIG_SYS_MX27_UART6) > +#define UART_PHYS 0x1001c000
Should that file be renamed? serial_mx31.c does not seem correct any more... And - what are these constants? I smell addresses? Unse I/O accessors instead? Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Overdrawn? But I still have checks left! _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot