On Monday 07 April 2014 10:51 PM, Tom Rini wrote:
On Thu, Apr 03, 2014 at 08:45:42PM +0530, Jagan Teki wrote:
On Thu, Apr 3, 2014 at 5:22 PM, Tom Rini<tr...@ti.com> wrote:
From: "Poddar, Sourav"<sourav.pod...@ti.com>
Bulk erase is not happening properly on dra7 due to erase timing constraints,
add a delay so that erase timing constraints are properly met.
Signed-off-by: Sourav Poddar<sourav.pod...@ti.com>
Tested-by: Yebio Mesfin<ymes...@ti.com>
---
drivers/spi/ti_qspi.c | 3 +++
1 file changed, 3 insertions(+)
diff --git a/drivers/spi/ti_qspi.c b/drivers/spi/ti_qspi.c
index dfa5d0c..c5d2245 100644
--- a/drivers/spi/ti_qspi.c
+++ b/drivers/spi/ti_qspi.c
@@ -314,6 +314,9 @@ int spi_xfer(struct spi_slave *slave, unsigned int bitlen,
const void *dout,
qslave->cmd |= QSPI_RD_SNGL;
debug("rx cmd %08x dc %08x\n",
qslave->cmd, qslave->dc);
+ #ifdef CONFIG_DRA7XX
+ udelay(500);
+ #endif
writel(qslave->cmd,&qslave->base->cmd);
status = readl(&qslave->base->status);
timeout = QSPI_TIMEOUT;
Can't we fix this? discussed the same in previous version thread as well.
Sorry, I kicked out v2 before checking my mbox again. Sourav, do you
have some time to look at this again?
I can look at this sometime this week, but I am not sure if there is
anything which
can be done. I had tried few stuffs to get rid of this in the past, but
those attempts failed.
Still, I will check if there is anything more that can be done to get
rid of this.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot