From: Tom Rini <tr...@ti.com>
The s_init function is only called on SPL or XIP cases, so lets only
build it for them. This makes the #if logic within the function a bit
clearer as to when we are or are not calling things, and makes it easier
to see that for example preloader_console_init isn't ever called in the
non-XIP full U-Boot case.
Signed-off-by: Tom Rini <tr...@ti.com>
Signed-off-by: Sourav Poddar <sourav.pod...@ti.com>
---
arch/arm/cpu/armv7/am33xx/board.c | 8 +++-----
1 file changed, 3 insertions(+), 5 deletions(-)
diff --git a/arch/arm/cpu/armv7/am33xx/board.c
b/arch/arm/cpu/armv7/am33xx/board.c
index 2b15a64..fb44cc8 100644
--- a/arch/arm/cpu/armv7/am33xx/board.c
+++ b/arch/arm/cpu/armv7/am33xx/board.c
@@ -202,6 +202,7 @@ static void watchdog_disable(void)
}
#endif
+#if defined(CONFIG_SPL_BUILD) || defined(CONFIG_NOR_BOOT)
void s_init(void)
{
/*
@@ -220,22 +221,19 @@ void s_init(void)
#ifdef CONFIG_SPL_BUILD
save_omap_boot_params();
#endif
-#if defined(CONFIG_SPL_BUILD) || defined(CONFIG_NOR_BOOT)
watchdog_disable();
timer_init();
set_uart_mux_conf();
setup_clocks_for_console();
uart_soft_reset();
-#endif
#ifdef CONFIG_NOR_BOOT
gd->baudrate = CONFIG_BAUDRATE;
serial_init();
gd->have_console = 1;
-#else
+#elif defined(CONFIG_SPL_BUILD)
gd = &gdata;
preloader_console_init();
#endif
-#if defined(CONFIG_SPL_BUILD) || defined(CONFIG_NOR_BOOT)
prcm_init();
set_mux_conf_regs();
#if defined(CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC)
@@ -243,8 +241,8 @@ void s_init(void)
rtc32k_enable();
#endif
sdram_init();
-#endif
}
+#endif
#ifndef CONFIG_SYS_DCACHE_OFF
void enable_caches(void)
--
1.7.9.5
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
