Hi Rik,
On Fri, 30 May 2014 10:50:39 +0000 (UTC) Rik Smith <rsm...@optos.com> wrote: > Chin Liang See <clsee <at> altera.com> writes: > > > > > To add the Denali NAND driver support into U-Boot. It required > > information such as register base address from configuration > > header file within include/configs folder. > > > > Signed-off-by: Chin Liang See <clsee <at> altera.com> > > Cc: Artem Bityutskiy <artem.bityutskiy <at> linux.intel.com> > > Cc: David Woodhouse <David.Woodhouse <at> intel.com> > > Cc: Brian Norris <computersforpeace <at> gmail.com> > > Cc: Scott Wood <scottwood <at> freescale.com> > > --- > > Changes for v2 > > - Enable this driver support for SOCFPGA > > --- > > drivers/mtd/nand/Makefile | 1 + > > drivers/mtd/nand/denali_nand.c | 1166 > ++++++++++++++++++++++++++++++++++++++++ > > drivers/mtd/nand/denali_nand.h | 501 +++++++++++++++++ > > 3 files changed, 1668 insertions(+) > > create mode 100644 drivers/mtd/nand/denali_nand.c > > create mode 100644 drivers/mtd/nand/denali_nand.h > > > > Hi, > I was wondering which kernel this patch went into or is going into? > > I am having problems with accessing a hynix NAND from an altera cyclone V > using kernel 3.11. It is coming up with a kernel driver error on boot of: > "Your NAND chip OOB is not large enough to contain 8bit ECC correction codes" This is not a driver for Linux Kernel, but for U-Boot (boot loader). Best Regards Masahiro Yamada _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot