Hi Chris, On 5 June 2014 21:24, Chris Packham <judge.pack...@gmail.com> wrote: > Hi, > > (Joe, Simon, I'm not sure if this counts as "networking" or "driver > model" but figured it was close enough to warrant an Cc). > > We're looking at a new board design and are planning on using a > BCM5718 to provide a couple of Ethernet ports. The chipset is > supported in Linux using the tg3.c driver. I was planning on creating > an equivalent driver in u-boot using e1000.c as a guide and probably > borrowing heavily from the Linux driver. > > Is anyone else actively looking at Broadcom based chipset/NICs? Any > tips as for where to start or pitfalls to expect?
I'm not aware of anything myself, but it sounds like a good idea. If you feel able to convert 'eth' over to driver model that would be great too. There are only a small number of operations. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
