Thanks for the much waited reply. > I've only tried my patch on i.MX27 board. I mentioned that it may work > on MX3's too cause the kernel driver used as a source works on both MX2 > and MX3. You need to do some changes for my driver to work on MX3. Check > the pins configuration and if you have MCI clock signal enabled. As a quickstart, I am actually trying to look at the mxcmci_probe() for the init stuff. I hope thats the correct approach for finding the initialization stuff. Another For the GPIOs to set the signals right(data/clk/cmd) , i am using the following chunk of code.
Also > you should use another function to get the clock rate on MX31. Sorry, I > can't debug the driver on mx31 now, you should do it yourself. Apologize if i had menat that in my emails, i never meant that you test it on the mx31 board >Probably you may also want to discard my generic mmc patches (except for this > one) and pull from u-boot-mmc tree instead. Would it matter even if i use the patch? _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
