Hi York, On 20-06-14 20:46, York Sun wrote:
From: "J. German Rivera" <german.riv...@freescale.com>Adding support to load and start the Layerscape Management Complex (MC) firmware. First, the MC GCR register is set to 0 to reset all cores. MC firmware and DPL images are copied from their location in NOR flash to DDR. MC registers are updated with the location of these images. Deasserting the reset bit of MC GCR register releases core 0 to run. Core 1 will be released by MC firmware. Stop bits are not touched for this step. U-boot waits for MC until it boots up. In case of a failure, device tree is updated accordingly. The MC firmware image uses FIT format. +int parse_mc_firmware_fit_image(const void **raw_image_addr, + size_t *raw_image_size) +{ + int format; + void *fit_hdr; + int node_offset; + const void *data; + size_t size; + const char *uname = "firmware"; + + /* Check if the image is in NOR flash*/ +#ifdef CONFIG_SYS_LS_MC_FW_IN_NOR + fit_hdr = (void *)CONFIG_SYS_LS_MC_FW_ADDR; +#else +#error "No CONFIG_SYS_LS_MC_FW_IN_xxx defined" +#endif + + /* Check if Image is in FIT format */ + format = genimg_get_format(fit_hdr); + + if (format != IMAGE_FORMAT_FIT) { + debug("Not a FIT image\n"); + return 1; + } + + if (!fit_check_format(fit_hdr)) { + debug("Bad FIT image format\n"); + return 1; + } + + /* Find node offset of MC Firmware image */ + if (uname == NULL) { + debug("FIT subimage unit name not provided"); + return 1; + } +
I don't see how uname can ever be NULL here, since it is assigned above. Regards, Jeroen _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
