Let PCI on mx6solox also be supported.
Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
---
Changes since v2:
- Configure lvds1_clk_sel in run-time
Changes since v1:
- Put the definition of gpc inside CONFIG_MX6SX ifdef
- Use setbits_le32 to configure register CNTR
- Improve comments in the code
arch/arm/cpu/armv7/mx6/clock.c | 17 +++++++++++----
arch/arm/include/asm/arch-mx6/iomux.h | 9 ++++++++
drivers/pci/pcie_imx.c | 40 +++++++++++++++++++++++++++++++----
3 files changed, 58 insertions(+), 8 deletions(-)
diff --git a/arch/arm/cpu/armv7/mx6/clock.c b/arch/arm/cpu/armv7/mx6/clock.c
index 820b8d5..18608de 100644
--- a/arch/arm/cpu/armv7/mx6/clock.c
+++ b/arch/arm/cpu/armv7/mx6/clock.c
@@ -509,6 +509,7 @@ int enable_pcie_clock(void)
struct anatop_regs *anatop_regs =
(struct anatop_regs *)ANATOP_BASE_ADDR;
struct mxc_ccm_reg *ccm_regs = (struct mxc_ccm_reg *)CCM_BASE_ADDR;
+ u32 lvds1_clk_sel;
/*
* Here be dragons!
@@ -518,17 +519,25 @@ int enable_pcie_clock(void)
* marked as ANATOP_MISC1 is actually documented in the PMU section
* of the datasheet as PMU_MISC1.
*
- * Switch LVDS clock source to SATA (0xb), disable clock INPUT and
- * enable clock OUTPUT. This is important for PCI express link that
- * is clocked from the i.MX6.
+ * Switch LVDS clock source to SATA (0xb) on mx6q/dl or PCI (0xa) on
+ * mx6sx, disable clock INPUT and enable clock OUTPUT. This is important
+ * for PCI express link that is clocked from the i.MX6.
*/
#define ANADIG_ANA_MISC1_LVDSCLK1_IBEN (1 << 12)
#define ANADIG_ANA_MISC1_LVDSCLK1_OBEN (1 << 10)
#define ANADIG_ANA_MISC1_LVDS1_CLK_SEL_MASK 0x0000001F
+#define ANADIG_ANA_MISC1_LVDS1_CLK_SEL_PCIE_REF 0xa
+#define ANADIG_ANA_MISC1_LVDS1_CLK_SEL_SATA_REF 0xb
+
+ if (is_cpu_type(MXC_CPU_MX6SX))
+ lvds1_clk_sel = ANADIG_ANA_MISC1_LVDS1_CLK_SEL_PCIE_REF;
+ else
+ lvds1_clk_sel = ANADIG_ANA_MISC1_LVDS1_CLK_SEL_SATA_REF;
+
clrsetbits_le32(&anatop_regs->ana_misc1,
ANADIG_ANA_MISC1_LVDSCLK1_IBEN |
ANADIG_ANA_MISC1_LVDS1_CLK_SEL_MASK,
- ANADIG_ANA_MISC1_LVDSCLK1_OBEN | 0xb);
+ ANADIG_ANA_MISC1_LVDSCLK1_OBEN | lvds1_clk_sel);
/* PCIe reference clock sourced from AXI. */
clrbits_le32(&ccm_regs->cbcmr, MXC_CCM_CBCMR_PCIE_AXI_CLK_SEL);
diff --git a/arch/arm/include/asm/arch-mx6/iomux.h
b/arch/arm/include/asm/arch-mx6/iomux.h
index f54db69..9b3a91f 100644
--- a/arch/arm/include/asm/arch-mx6/iomux.h
+++ b/arch/arm/include/asm/arch-mx6/iomux.h
@@ -19,6 +19,12 @@
#define IOMUXC_GPR1_TEST_POWERDOWN (1 << 18)
/*
+ * IOMUXC_GPR5 bit fields
+ */
+#define IOMUXC_GPR5_PCIE_BTNRST (1 << 19)
+#define IOMUXC_GPR5_PCIE_PERST (1 << 18)
+
+/*
* IOMUXC_GPR8 bit fields
*/
#define IOMUXC_GPR8_PCS_TX_DEEMPH_GEN1_MASK (0x3f << 0)
@@ -35,12 +41,15 @@
/*
* IOMUXC_GPR12 bit fields
*/
+#define IOMUXC_GPR12_RX_EQ_2 (0x2 << 0)
+#define IOMUXC_GPR12_RX_EQ_MASK (0x7 << 0)
#define IOMUXC_GPR12_LOS_LEVEL_9 (0x9 << 4)
#define IOMUXC_GPR12_LOS_LEVEL_MASK (0x1f << 4)
#define IOMUXC_GPR12_APPS_LTSSM_ENABLE (1 << 10)
#define IOMUXC_GPR12_DEVICE_TYPE_EP (0x0 << 12)
#define IOMUXC_GPR12_DEVICE_TYPE_RC (0x4 << 12)
#define IOMUXC_GPR12_DEVICE_TYPE_MASK (0xf << 12)
+#define IOMUXC_GPR12_TEST_POWERDOWN (1 << 30)
/*
* IOMUXC_GPR13 bit fields
diff --git a/drivers/pci/pcie_imx.c b/drivers/pci/pcie_imx.c
index a3982c4..fd7e4d4 100644
--- a/drivers/pci/pcie_imx.c
+++ b/drivers/pci/pcie_imx.c
@@ -23,13 +23,20 @@
#define PCI_ACCESS_READ 0
#define PCI_ACCESS_WRITE 1
+#ifdef CONFIG_MX6SX
+#define MX6_DBI_ADDR 0x08ffc000
+#define MX6_IO_ADDR 0x08000000
+#define MX6_MEM_ADDR 0x08100000
+#define MX6_ROOT_ADDR 0x08f00000
+#else
#define MX6_DBI_ADDR 0x01ffc000
-#define MX6_DBI_SIZE 0x4000
#define MX6_IO_ADDR 0x01000000
-#define MX6_IO_SIZE 0x100000
#define MX6_MEM_ADDR 0x01100000
-#define MX6_MEM_SIZE 0xe00000
#define MX6_ROOT_ADDR 0x01f00000
+#endif
+#define MX6_DBI_SIZE 0x4000
+#define MX6_IO_SIZE 0x100000
+#define MX6_MEM_SIZE 0xe00000
#define MX6_ROOT_SIZE 0xfc000
/* PCIe Port Logic registers (memory-mapped) */
@@ -57,6 +64,8 @@
#define PHY_RX_OVRD_IN_LO_RX_DATA_EN (1 << 5)
#define PHY_RX_OVRD_IN_LO_RX_PLL_EN (1 << 3)
+#define PCIE_PHY_PUP_REQ (1 << 7)
+
/* iATU registers */
#define PCIE_ATU_VIEWPORT 0x900
#define PCIE_ATU_REGION_INBOUND (0x1 << 31)
@@ -421,9 +430,19 @@ static int imx_pcie_write_config(struct pci_controller
*hose, pci_dev_t d,
static int imx6_pcie_assert_core_reset(void)
{
struct iomuxc *iomuxc_regs = (struct iomuxc *)IOMUXC_BASE_ADDR;
-
+#if defined(CONFIG_MX6SX)
+ struct gpc *gpc_regs = (struct gpc *)GPC_BASE_ADDR;
+
+ /* SSP_EN is not used on MX6SX anymore */
+ setbits_le32(&iomuxc_regs->gpr[12], IOMUXC_GPR12_TEST_POWERDOWN);
+ /* Force PCIe PHY reset */
+ setbits_le32(&iomuxc_regs->gpr[5], IOMUXC_GPR5_PCIE_BTNRST);
+ /* Power up PCIe PHY */
+ setbits_le32(&gpc_regs->cntr, PCIE_PHY_PUP_REQ);
+#else
setbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_TEST_POWERDOWN);
clrbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_REF_SSP_EN);
+#endif
return 0;
}
@@ -441,6 +460,12 @@ static int imx6_pcie_init_phy(void)
IOMUXC_GPR12_LOS_LEVEL_MASK,
IOMUXC_GPR12_LOS_LEVEL_9);
+#ifdef CONFIG_MX6SX
+ clrsetbits_le32(&iomuxc_regs->gpr[12],
+ IOMUXC_GPR12_RX_EQ_MASK,
+ IOMUXC_GPR12_RX_EQ_2);
+#endif
+
writel((0x0 << IOMUXC_GPR8_PCS_TX_DEEMPH_GEN1_OFFSET) |
(0x0 << IOMUXC_GPR8_PCS_TX_DEEMPH_GEN2_3P5DB_OFFSET) |
(20 << IOMUXC_GPR8_PCS_TX_DEEMPH_GEN2_6DB_OFFSET) |
@@ -517,9 +542,16 @@ static int imx6_pcie_deassert_core_reset(void)
*/
mdelay(50);
+#if defined(CONFIG_MX6SX)
+ /* SSP_EN is not used on MX6SX anymore */
+ clrbits_le32(&iomuxc_regs->gpr[12], IOMUXC_GPR12_TEST_POWERDOWN);
+ /* Clear PCIe PHY reset bit */
+ clrbits_le32(&iomuxc_regs->gpr[5], IOMUXC_GPR5_PCIE_BTNRST);
+#else
/* Enable PCIe */
clrbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_TEST_POWERDOWN);
setbits_le32(&iomuxc_regs->gpr[1], IOMUXC_GPR1_REF_SSP_EN);
+#endif
imx6_pcie_toggle_reset();
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
