On Monday, September 15, 2014 at 06:00:47 PM, Dinh Nguyen wrote: > On 09/15/2014 06:05 AM, Marek Vasut wrote: > > From: Pavel Machek <pa...@denx.de> > > > > The dw_mmc driver was responding to errors with debug(). Change that > > to prinf()/puts() respectively so that any errors are immediately > > obvious. Also adjust english in comments.
[...] > > @@ -290,7 +292,7 @@ static void dwmci_set_ios(struct mmc *mmc) > > > > struct dwmci_host *host = (struct dwmci_host *)mmc->priv; > > u32 ctype, regs; > > > > - debug("Buswidth = %d, clock: %d\n",mmc->bus_width, mmc->clock); > > + debug("Buswidth = %d, clock: %d\n", mmc->bus_width, mmc->clock); > > Did you intend to use printf here also? Or just fix up the spacing > around mmc->bus_width? This cannot be a printf(), since you would get an output upon every call of .set_ios(). This would generate a wall of text. So this is formatting fix. Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot