Add support for WVGA (800x480) panels using VESA GTF timings over
LVDS.
No auto-detection is supported, so you must configure this panel
manually through the 'panel' environment variable:
U-Boot > setenv panel svga
U-Boot > saveenv && reset
Signed-off-by: Eric Nelson <eric.nel...@boundarydevices.com>
---
board/boundary/nitrogen6x/nitrogen6x.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/board/boundary/nitrogen6x/nitrogen6x.c
b/board/boundary/nitrogen6x/nitrogen6x.c
index c91e0c4..115ee81 100644
--- a/board/boundary/nitrogen6x/nitrogen6x.c
+++ b/board/boundary/nitrogen6x/nitrogen6x.c
@@ -680,6 +680,26 @@ struct display_info_t const displays[] = {{
.sync = FB_SYNC_EXT,
.vmode = FB_VMODE_NONINTERLACED
} }, {
+ .bus = 0,
+ .addr = 0,
+ .pixfmt = IPU_PIX_FMT_LVDS666,
+ .detect = 0,
+ .enable = enable_lvds,
+ .mode = {
+ .name = "wvga-lvds",
+ .refresh = 57,
+ .xres = 800,
+ .yres = 480,
+ .pixclock = 15385,
+ .left_margin = 220,
+ .right_margin = 40,
+ .upper_margin = 21,
+ .lower_margin = 7,
+ .hsync_len = 60,
+ .vsync_len = 10,
+ .sync = FB_SYNC_EXT,
+ .vmode = FB_VMODE_NONINTERLACED
+} }, {
.bus = 2,
.addr = 0x48,
.pixfmt = IPU_PIX_FMT_RGB666,
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
