U-Boot 2014.07 I'm trying to use ping 44..47 as input. I've configured PINMUX and invoked request, direction etc. I always get 0 from gpio_get_value()
int val; gpio_request(44, "dip_s1"): gpio_request(45, "dip_s2"); gpio_request(46, "dip_s3"); gpio_request(47, "dip_s4"); gpio_direction_input(44); gpio_direction_input(45); gpio_direction_input(46); gpio_direction_input(47); val = gpio_get_value(44); printf("DIP value: %d\n", val); val = gpio_get_value(45); printf("DIP value: %d\n", val); val = gpio_get_value(46); printf("DIP value: %d\n", val); val = gpio_get_value(47); printf("DIP value: %d\n", val); After reading http://e2e.ti.com/support/arm/sitara_arm/f/791/t/248181.aspx I've checked clock registers CM_PER_L4LS_CLKSTCTRL (bit 8 L4LS_GCLK is set) and also CM_PER_GPIO1_CLKCTRL has value 2 - enabled. I can also see, that arch/arm/cpu/armv7/am33xx/clock_am33xx.c->enable_basic_clocks() enables clocks for GPIO1. Then I checked GPIO1 specific registers and found out, that GPIO_SYSSTATUS (0x4804C114) shows 0x00000000 i.e. GPIO is still in reset. Any idea, what should be activated/setup in order to get the second GPIO bank working? Thanks. Yegor _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot