On Thu, Jun 04, 2009 at 08:42:40AM +0200, Stefan Roese wrote: > > defaults: > > mtdids : nand0=nand0 > > mtdparts: > > mtdparts=nand0:512k(u-boot),128k(env),384k(splash),3M(kernel),-(ubilayer) $ > > ubi part ubilayer > > Creating 1 MTD partitions on "nand0": > > 0x00400000-0x08000000 : "mtd=4" > > UBI: attaching mtd1 to ubi0 > > UBI: physical eraseblock size: 131072 bytes (128 KiB) > > UBI: logical eraseblock size: 126976 bytes > > UBI: smallest flash I/O unit: 2048 > > UBI: VID header offset: 2048 (aligned 2048) > > UBI: data offset: 4096 > > UBI error: ubi_init: cannot attach mtd1 > > UBI error: ubi_init: UBI error: cannot initialize UBI, error -12 > > UBI init error -12 > > exit not allowed from main input shell. > > Did you erase the FLASH partition? If not please try again after erasing.
I used ubiformat from Linux using /dev/ubi0 which is attached to /dev/mtd4 which again points to the same area in the flash than 'ubilayer' does in U-Boot. So I should be able to access that same volume from the bootloader, right? Or do I miss some important point? Thanks, Daniel _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot