Dear Wolfgang,
Dear Reinhard,
In message <544f6ad8.2070...@emk-elektronik.de> you wrote:
top860 can be removed (We already had that discussion a while ago.)
top5200 is still active in several older projects, but there was no need
to make changes to u-boot or to integrate new features of u-boot.
Therefore I am not testing whether any changes to u-boot break the
function of top5200.
top9000 is dead. Thanks atmel :(
However it might be left in u-boot as an example.
Hm... if two of the boards are dead, and you are not even testing the
third, can we not just remove all of them? That would also allow to
get rid of board/emk/common:
Agreed.
- am79c874.c is completely bogus anyway
How so?
- flash.c should have been replaced by the CFI driver years ago
I think there was/is an issue with the fact that top5200 uses GPIO for
the uppermost (A16+) address lines AND that FLASH is connected 8 Bit wide.
Maybe CFI code does support such by now, at that time it did not.
- vpd.c is causing efforts when I2C / EEPROM code gets changed
ideally, the API should not change that often ;)
What do you think?
Since its quite unlikely I will make any changes to those boards in the
future, they can be removed.
Best Regards,
Reinhard
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
