On Monday, November 10, 2014 at 02:01:50 AM, Peng Fan wrote:
[...]
> >> +
> >> in usb_phy_mode, query a PHY for it's mode.
> >>
> >> And righter after usb_phy_enable in ehci-mx6.c.
> >> - type = usb_phy_enable(index, ehci) ? USB_INIT_DEVICE :
> >> USB_INIT_HOST;
> >> + usb_phy_enable(index, ehci);
> >> + type = usb_phy_mode(index);
> >>
> >> usb_phy_enable return 0 but not return val & USBPHY_CTRL_OTG_ID. There
> >> is no status bit for query enabled or not, so just return 0.
> >>
> >> In board file:
> >> int board_usb_phy_mode(int port)
> >> {
> >>
> >> if (port == 1)
> >>
> >> return USB_INIT_HOST;
> >>
> >> else
> >>
> >> return usb_phy_mode(port);
> >>
> >> }
> >>
> >> I think this is better way then previous patch, but i did not find where
> >> to put the usb_phy_mode prototype type, since board file will use it.
> >
> > Looks OK otherwise.
>
> Sent out v4 patch, please review.
Thanks! Will do as time permits. Sorry for possible delays.
Best regards,
Marek Vasut
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
