On 14/11/2014 14:27, Fabio Estevam wrote: > From: Fabio Estevam <fabio.este...@freescale.com> > > mx6sabreauto boards come with 32 MiB of parallel NOR flash. > > Add support for it: > > U-Boot 2015.01-rc1-18107-g1543636-dirty (Nov 14 2014 - 11:11:04) > > > > CPU: Freescale i.MX6Q rev1.2 at 792 MHz > > Reset cause: POR > > Board: MX6Q-Sabreauto revA > > I2C: ready > > DRAM: 2 GiB > > Flash: 32 MiB > > NAND: 0 MiB > > > Due to pin conflict with I2C3, only define configure I2C3 IOMUX when flash is > not used. > > Signed-off-by: Fabio Estevam <fabio.este...@freescale.com> > ---
Applied to u-boot-imx, thanks ! Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot