Hello Simon,
On 11/18/2014 10:17 AM, vikasm wrote:
Hello Simon,
On 11/17/2014 09:19 PM, Simon Glass wrote:
Hi Vikas,
On 18 November 2014 01:30, Vikas Manocha <vikas.mano...@st.com> wrote:
This patchset add support for new arch stv0991.
Changes in v4:
- rebased to current master
- added maintainers info
Changes in v3:
- removed period from commit messages
Changes in v2:
- corrected files license to GPL-2.0+
- replaced printf() usage with puts() for string print
- sorted sourcing of board Kconfig
Vikas Manocha (4):
stv0991: Add basic stv0991 architecture support
stv0991: enable ethernet support
stv0991: default + misc command configs enabled
stv0991: add maintainer information
Can you please look at using driver model for this board? It would be
particularly valuable since it looks like you are using the pl011 UART
which has not previously been tested with driver model (and it seems
you found some problems).
To do this you probably only need to adjust a few defines and add
platform data for serial. A patch for Raspberry Pi is here:
http://patchwork.ozlabs.org/patch/392180/
Sure, Simon. Infact i was also planning to use the driver model.
Thanks for sharing the Raspberry patch link.
I tried using driver model but got into issue after relocation, figured
out that it was because 0x0 location
was being overwritten & pl011 base address was being stored here...
After tracking "Raspberry Pi with driver model" discussion, seems like
you are aware of it now, just wanted
to provide this information on one more platform.
Rgds,
Vikas
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
