Hi Peter, On 2 December 2014 at 14:59, Peter Howard <p...@northern-ridge.com.au> wrote: > > I'm trying to make two changes to building u-boot for the da850evm. > * Use the generic board code to get rid of the warning, and > * Enable libfdt to allow booting of linux with a standalone dtb > image. > > The first part appears to be simple. Just adding > > #define CONFIG_SYS_GENERIC_BOARD > > in include/configs/da850evm.h works with no obvious side-effects. > > However, adding > > #define CONFIG_OF_LIBFDT > > is a different story. It appears to introduce memory corruption when > loading the environment. On first boot it gives the "bad CRC!" warning > and uses the default environment. If you *don't* save the environment > you can boot fine (including manual editing of the environment). However > if you save the environment via saveenv bad things happen on the next > boot. An example log: > > U-Boot SPL 2015.01-rc1 (Nov 27 2014 - 14:30:26) > > > U-Boot 2015.01-rc1 (Nov 27 2014 - 14:30:26) > > I2C: ready > DRAM: 64 MiB > WARNING: Caches not enabled > MMC: davinci: 0 > SF: Detected M25P64 with page size 256 Bytes, erase size 64 KiB, total 8 MiB > In: serial > Out: serial > Err: serial > SF: Detected M25P64 with page size 256 Bytes, erase size 64 KiB, total 8 MiB > Warning: Invalid MAC address read from SPI flash > Net: DaVinci-EMAC > Error: DaVinci-EMAC address not set. > > U-Boot > help > data abort > pc : [<c108ffd8>] lr : [<c10900b4>] > sp : c3e5f838 ip : 00000000 fp : c3e5fda4 > r10: c10b1f28 r9 : c3e5ff08 r8 : 0000000e > r7 : c10b22c4 r6 : c10aa2a0 r5 : 00000000 r4 : 0000001b > r3 : c10b8f70 r2 : 00000001 r1 : c3e5f840 r0 : ffffffff > Flags: Nzcv IRQs off FIQs off Mode SVC_32 > Resetting CPU ... > > If I rebuild with CONFIG_OF_LIBFDT removed again from da850evm.h the > problem disappears. And you can see that the saveenv worked (i.e. the > environment is what was saved before the reboot and data abort). > > I've traced the problem as far as the inline version of console_puts() > in common/console.c. The table dispatch there and the fact that the > problem appears only when you load the environment makes me think it's > memory corruption. > > Note: if you do *not* specify CONFIG_SYS_GENERIC_BOARD you still get the > data abort, however it takes a bit more effort to trigger (like actually > looking at the environment :-) ) > > (Note: This is building against the u-boot-2015.01-rc1 tree) > > Suggestions?
In case it helps, I got the same symptom (help crashes) and it was due to BSS not being cleared. Stefan (on cc) found this problem - he said something to do with GDT calculation or handling. However it is just a guess and probably has nothing to do with your issue. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot