Hi Andrew,
> On Dec 1, 2014, at 14:59 , Andrew Gabbasov <andrew_gabba...@mentor.com> wrote:
>
> Since the driver doesn't work in 1.2V or 1.8V signaling level modes,
> Dual Data Rate mode can be supported by the driver only if it is supported
> by the card in regular 3.3V mode. So, check for a particular single
> bit in card type field.
>
> Signed-off-by: Andrew Gabbasov <andrew_gabba...@mentor.com>
> ---
> drivers/mmc/mmc.c | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
> index 4603a81..d878c1e 100644
> --- a/drivers/mmc/mmc.c
> +++ b/drivers/mmc/mmc.c
> @@ -519,7 +519,7 @@ static int mmc_change_freq(struct mmc *mmc)
>
> /* High Speed is set, there are two types: 52MHz and 26MHz */
> if (cardtype & EXT_CSD_CARD_TYPE_52) {
> - if (cardtype & EXT_CSD_CARD_TYPE_DDR_52)
> + if (cardtype & EXT_CSD_CARD_TYPE_DDR_1_8V)
> mmc->card_caps |= MMC_MODE_DDR_52MHz;
> mmc->card_caps |= MMC_MODE_HS_52MHz | MMC_MODE_HS;
> } else {
> --
> 2.1.0
Applied, thanks.
— Pantelis
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
