Am Dienstag 23 Juni 2009 14:06:46 schrieb Prafulla Wadaskar: > > -----Original Message----- > > From: Dieter Kiermaier [mailto:dk-arm-li...@gmx.de] > > Sent: Tuesday, June 23, 2009 4:53 PM > > To: Prafulla Wadaskar > > Cc: Jean-Christophe PLAGNIOL-VILLARD; u-boot@lists.denx.de; > > Scott Wood; Ashish Karkare; Prabhanjan Sarnaik; Ronen Shitrit > > Subject: Re: [U-Boot] [PATCH v2 1/3][repost] nand: Add > > Marvell Kirkwood NAND driver > > > > Am Dienstag 23 Juni 2009 12:38:05 schrieb Prafulla Wadaskar: > > > > -----Original Message----- > > > > From: Dieter Kiermaier [mailto:dk-arm-li...@gmx.de] > > > > Sent: Tuesday, June 23, 2009 2:18 PM > > > > To: Jean-Christophe PLAGNIOL-VILLARD > > > > Cc: Prafulla Wadaskar; u-boot@lists.denx.de; Scott Wood; Ashish > > > > Karkare; Prabhanjan Sarnaik; Ronen Shitrit > > > > Subject: Re: [U-Boot] [PATCH v2 1/3][repost] nand: Add Marvell > > > > Kirkwood NAND driver > > > > > > > > Am Dienstag 23 Juni 2009 10:35:31 schrieb Jean-Christophe > > > > > > > > PLAGNIOL-VILLARD: > > > > > > > I2C lowest priority (as per need) > > > > > > > > > > > > Can I do something to push I2C priority? > > > > > > Any way this driver will be arround TWSI controller > > > > interface by h/w > > > > > Again if you are using different pins then may not be > > > > helpful for you > > > > I2C by hardware is ok because the pins are not multiplexed > > with other important functions as its the case for SPI. > > And also I2C isn't _so_ important to bring up the first board > > revision :) > > > > > > > If the I/O is shared with gpio you can use bitbanging with few > > > > > hours > > > > > > > > I think this would be the best to start - due to the fact that I > > > > need bitbanging for FPGA flashing, too. > > > > > > This is a good Idea, start your development with accessing GPIO > > > registers directly > > > > I start working on gpio stuff now and sending my patches to > > you. Maybe it is helpful for others, too, > > You are most welcomed as one of kirkwood developer for u-boot community > Post your patches to mailing list so that everyone can review and provide > you feedback, follow u-boot development guidelines, go through u-boot > development documentation.. > > Best of luck :-) > Thanks to all - it's time to give something back to the community :) And sure - I will send the patches as well to the list!
Dieter > Regards.. > Prafulla . . > > > Dieter > > > > > Regards.. > > > Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot