Hi Marek, On 26 March 2015 at 13:40, Marek Vasut <ma...@denx.de> wrote: > On Wednesday, March 25, 2015 at 07:21:48 PM, Simon Glass wrote: >> This series adds driver model support to USB. The intent is to permit the >> various subsystems (OHCI, EHCI, XHCI) to co-exist and allow any number of >> USB ports of different types. >> >> With the RFC series, only USB controllers had a real driver model device. >> USB devices (including the hub in the controller) were not modelled as >> driver model devices. >> >> While this was expedient, and produced much fewer patches, it is not a >> long-term solution. Also, since then, driver model Ethernet support (which >> USB can use) has been merged to u-boot-dm/next. It seems better to bite the >> bullet and do a full conversion. > > Whew. > > Reviewed-by: Marek Vasut <ma...@denx.de>
Thanks very much for working through these! Unless there are other comments I plan to apply this to u-boot-dm/next in the next few days. I expect it will need some tweaking as boards are moved over too. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
