u-boot breaks for the Overo boards since the following
commit: a6b541b09022acb6f7c2754100ae26bd44eed1d9
This is because the gd pointer is not set early enough anymore,
such that the i2c_set_bus_num in get_board_revision can safely
execute. This results in a console hang at SPL and the boot does
not proceed.
This piece of code is anyway necessary only for really old Overo
boards with revision numbers <= 2410 and not required for the newer
boards. For these older boards, u-boot v2014.10 still works fine.
Signed-off-by: Arun Bharadwaj <a...@gumstix.com>
---
board/overo/spl.c | 14 --------------
1 file changed, 14 deletions(-)
diff --git a/board/overo/spl.c b/board/overo/spl.c
index d101c68..e1652c3 100644
--- a/board/overo/spl.c
+++ b/board/overo/spl.c
@@ -29,20 +29,6 @@ int get_board_revision(void)
{
int revision;
-#ifdef CONFIG_SYS_I2C_OMAP34XX
- unsigned char data;
-
- /* board revisions <= R2410 connect 4030 irq_1 to gpio112
*/
- /* these boards should return a revision number of 0
*/
- /* the code below forces a 4030 RTC irq to ensure that gpio112 is low
*/
- i2c_set_bus_num(TWL4030_I2C_BUS);
- data = 0x01;
- i2c_write(0x4B, 0x29, 1, &data, 1);
- data = 0x0c;
- i2c_write(0x4B, 0x2b, 1, &data, 1);
- i2c_read(0x4B, 0x2a, 1, &data, 1);
-#endif
-
if (!gpio_request(112, "") &&
!gpio_request(113, "") &&
!gpio_request(115, "")) {
--
1.9.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
